Keywords
- adjustment (5)
- airbag (1)
- antivibration (12)
- arm (43)
- axial mounting (140)
- axis (61)
- axis stop (47)
- bracket (1)
- building (15)
- cable (153)
- cage (207)
- cap (36)
- carpet (1)
- chimney nut (2)
- clamp (25)
- clearance (25)
- clearance adjustment (2)
- clip (304)
- connector (35)
- cover (1)
- crimping nut (2)
- dismantleable (77)
- earth continuity (16)
- elastic ring (41)
- electrical appliances (5)
- electricity (46)
- end stop (5)
- expansion (60)
- exterior trim (44)
- fool proofing (4)
- grommet (21)
- heavy duty (36)
- helical cage (5)
- internal trim (127)
- invisible (139)
- monogram fastener (18)
- multi-panel (33)
- nut (248)
- omega (3)
- over moulded (9)
- partial rotation (4)
- pilot point (9)
- plug (56)
- premounting (23)
- profile (3)
- protection (45)
- quarter turn (13)
- radial mounting (48)
- removable (138)
- retaining washer (6)
- ribbon (4)
- rivet (36)
- rod (19)
- round hole (196)
- S clip (1)
- screw (18)
- seal (11)
- seat (9)
- self locking (1)
- single thread engagement (2)
- sink (2)
- spacer (15)
- stowing tie (1)
- strap (6)
- stud fastener (138)
- threaded stud (30)
- to clip
- to clip and snap (5)
- to scratch (4)
- to screw (4)
- to snap (90)
- to wedge (3)
- to weld (1)
- tool tightening (2)
- trim (290)
- tube spacer (9)
- tubular (3)
- twin shot (13)
- U shape (13)
- waterproofing (61)
- window sub frame clip (7)
- without thread (49)
Keywords
- Fasteners for tubes, wire-rods, cables, and harnesses
Fasteners for cables, wire-rods, tubes or harnesses on panels, profiles, or other cables.
- Fasteners for panels
To fasten two or more panels together without any nut or screw.
- Fasteners on shafts (1). Axial mounting.
To fasten axially, panels, buttons, badges... on a shaft.
- Fasteners on shafts (2). Radial or axial mounting.
To fasten radially or axially, panels, buttons, badges... on a shaft.
- Clips and rivets
Clipped in a hole to assemble together two or more panels, by the front face.
- Plugs, grommets, terminal rotation-proof washers
Holes closing in panels and tubes ends. Grommets, terminal rotation-proof washers.
- U nuts
U shaped nuts. Mounted on the side of the supporting panel.
- Nuts to be clipped
Mainly cage nuts. They are clipped in hole in the supporting panel.
- Flat nuts / PAL nuts
Nuts made of sheet metal, used without pre-assembling on their support
- Cage screws
Screws with a cage, in order to be clipped in a hole of a panel
- Special products
Fasteners for electrical components, sinks, external trims, wheel covers, seats, brakes… Anticreep rings, fluid connectors…